How to Set Up a Propane Fire Pit Table with Wicker Base

Quick answer

Set up your wicker propane fire pit table by placing the base on level ground, inserting the burner assembly, connecting the propane tank with a gas line, and leak-testing before first use.

Step-by-step setup process

1. 1. Position the wicker base on a level surface: Place the fire pit table on a stable, non-flammable surface like concrete, stone, or brick. Keep it at least 10 feet away from structures, trees, and overhangs. Check that the base is level using a spirit level; an uneven base can cause the burner to tilt and create uneven flames. A level surface prevents flame instability and tipping hazards.
2. 2. Install the burner assembly and control panel: Remove the lid and insert the burner pan into the center opening of the wicker table. Secure it with the provided screws or clips. Attach the control panel to the front of the table, making sure the gas valve aligns with the burner orifice. Tighten all connections by hand; do not use tools that could strip the threads. Finger-tight is sufficient—overtightening can damage the valve or burner.
3. 3. Connect the propane tank: Place the 20-pound propane tank in the designated compartment inside the wicker base. Attach the gas hose to the tank valve by turning the coupling clockwise. Hand-tighten only. Open the tank valve slowly and listen for hissing. If you hear gas, close the valve and tighten the connection again. Always open the tank valve slowly to avoid a sudden gas surge.
4. 4. Leak-test all connections: Mix a solution of equal parts water and dish soap. Apply it to every connection point: the tank valve, hose coupling, control valve, and burner orifice. Open the tank valve fully. If bubbles appear at any joint, close the tank valve and tighten that connection. Repeat the test until no bubbles form. Never use a match or lighter to check for leaks—soap solution is the only safe method.
5. 5. Ignite and adjust the flame: Turn the control knob to the 'OFF' position, then open the tank valve. Press and turn the control knob to 'LOW' while pressing the pulse igniter button. You should hear a click and see a blue flame. Adjust the knob to your desired heat level. If the flame is yellow or uneven, close the valve and check for blockages in the burner ports. A blue flame with a yellow tip is normal; a completely yellow flame means incomplete combustion.
6. 6. Final safety check and first use: After the flame is stable, close the lid (if your model has one) to use as a table, or leave it open for full heat output. Never leave the fire pit unattended while lit. When finished, turn the control knob to 'OFF' and close the tank valve. Wait 10 minutes before replacing the lid to allow the burner to cool. Always shut off the tank valve first, then the control knob, to prevent gas from lingering in the hose.

Product facts

• Tangkula 52 Inches Wicker Patio Propane Fire Pit Table, Patiojoy 50,000 BTU: The Tangkula 52-inch wicker fire pit table has a pulse-igniting device and a 2-in-1 design that allows use as a coffee table or fire pit. This means you can ignite the flame without a lighter, and the removable lid lets you switch between dining and warmth quickly.